Project

General

Profile

Bug #856

Fix error 412.1 – AC amps switch

Added by tin about 9 years ago. Updated over 6 years ago.

Status:
Closed
Priority:
Normal
Assignee:
Target version:
Start date:
12/11/2013
Due date:
12/28/2013
% Done:

0%

Estimated time:

Description

Failure: Cannot measure 1.7V ±0.3V at A/D IN.

The 9.2mA ohms source is turned on to dump current through switch U323 (ACAL
pulled low) to the amps protection diodes (CR305 and CR309). The three diode voltage
drop is routed through U317 (/200uA pulled low), U320 (/ACA pulled low), U510
(REL3 pulled low), U526 and Q516 to the input buffer (Q512 and U520). The buffered
signal is tied to AMP IN.

The signal at AMP IN is then routed to the variable gain ampliÞer (VGA) and, being
positive, follows the non-inverting x1 path that consists of R530, Q509, Q507, U519,
R531, U509, Q501, and U516 to pin 12 of multiplexer U511.

The output (OUT) of the multiplexer is routed through buffer U342 to ACV/A. The signal
at ACV/A is routed through U320 (/AC pulled low) and applied to the A/D buffer
(U322), which is conÞgured for x1 gain. Measure 1.7V at A/D IN.

Also available in: Atom PDF